|
|
CIE Test Instruments Current Clamps |
| |
A great addition for any multi-meter, labscope scan tool combination. For example, test low current draws on fuel pumps, check for injector current ramping and ignition module tests, view waveforms on your labscope or simply connect it to your multi-meter for digital readings. |
|
Model CA-60A AC/DC mA Current Clamp
|
|
Uses two Hall-Effect sensors.
For use with any multi-meter with 200mV or/and 2V ranges for direct readout (with an input impedance of at least 1MΩ)
LED indicator lights up when clamp meter power is low
Zero adjustment knob to compensate the hysteresis effect in DC measurements
Transformer Ratio 10:1, 100:1
Output 1mV/10mA, 1mV/100mA
Current Range 0 to 60 Amps
Accuracy DC Amps ±1.5%, AC Amps ±2% (40Hz-2kHz), AC Amps ±4% (2kHz-10kHz), AC Amps ± 6% (10kHz-20kHz)
Jaw opening capability - (9mm Conductor)
Safety Design meets IEC 1010-1, 1010-2-032 CE
|
|
A quality addition to any scan tool, multi-meter or labscope. Accurately measure current and starter motor draws. For example, put the CA-600 with the Hanatech UltrascanPlus and view minimum and maximum starter motor current and battery draw. Save to PC or print out for diagnostic reports and reference information. |
|
Model CA-600A AC/DC Current Clamp
|
|
Uses 2 Hall-Effect sensors
For use with any multi-meter with 200mV or/and 2V ranges for direct readout (with an input impedance of at least 1MΩ)
LED indicator lights up when clamp meter power is low
Zero adjustment knob to compensate the hysteresis effect in DC measurements
Transformer Ratio 1000:1
Output 1mV/10mA, 1mV/Amp
Current Range 0 to 600 Amps
Accuracy DC Amps ±2% +2A, AC Amps ±% +2A (50Hz-400Hz)
Jaw opening capability - (30mm Conductor)
Safety Design meets IEC 1010-1, 1010-2-032 CE
|
|