Current Clamps

Grid View:

TA388 2000a Pico BNC+ current clamp

$438.02

PicoBNC+ current clamp: 2000A AC/DC To take advantage of the PicoBNC+ capabilities, the TA388 is powered from the laptop via the Scope. The shape of this new clamp has a nice narrow-width profile. The 2000A clamp is automatically recognised by PicoScope software when it is connected to the scope, and is auto-ranged in the software requiring no m..

TA473 Pico 60a BNC+ current clamp

$438.02

PicoBNC+ current clamp: 60A AC/DC To take advantage of the PicoBNC+ capabilities, this current clamp is powered from the laptop via the Scope. The shape of the new clamp is different and the performance is substantially higher than the previous clamp. The 60A clamp is automatically recognised by PicoScope software when it is connected to the Pic..

Pico 0-2000 BNC Amp Current Clamp

$452.10

The 200 A / 2000 A current clamp with BNC connector allows you to measure up to 2000 amps without cutting, or disconnecting or stripping wires. Simply clamp the jaws around the cable to be tested and plug the clamp into your PicoScope. Before the launch of this probe we recommended the TA019 (600 A) for working on the starting and..

Pico BNC 0-30 Amp Current Clamp

$397.87

The TA234 is a 30 A current clamp with BNC adaptor. The extended measuring jaws allow measurement in a confined space. When measuring DC, a simple thumbwheel on the probe allows zero adjustment. This current clamp is ideally suited for use with PicoScope oscilloscopes and features additional screening to reduce noise pickup. ..

Pico BNC 0-60 Amp Current Clamp

$296.84

The TA018 current clamp with BNC adaptor is ideal for use with PicoScope automotive oscilloscopes for measuring currents between 10 mA and 60 A. This enables the PicoScope to display current waveforms for fuel injectors and fuel pumps. The current clamp has two calibration settings, set by a slider switch on the handle of the probe. 1 mV/10 m..

Pico BNC 0-600 Amp Current Clamp

$296.84

The TA019 current clamp with BNC connector is ideal for use with a PicoScope automotive oscilloscope to display starter current waveforms, charging currents and for performing quick compression tests. The current clamp can measure up to 600 A (AC or DC). In use there is no need to break into the circuit or disturb the isolation as the ..

TA496 PicoBNC+ 60 A DC compact current clamp

$374.42

The PicoBNC+® equipped TA496 is a natural choice if you are a PicoScope 4225A and 4425A user looking to add a compact low amps clamp to your PicoScope probe collection. The PicoBNC+® 60 A DC compact current clamp’s reduced form factor fits comfortably in your hand and improves accessibility in tight and difficult to access test loc..

Showing 1 to 7 of 7 (1 Pages)